Help! Triac PC 1996

All info relating to the Denford Triac series of CNC milling machines

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
vpmayer
Posts: 3
Joined: Tue 10 Jan , 2012 20:10 pm
Hardware/Software: TriacPC SN: EO4706M/3 Software: 2.93

MiracPC SN: EO4706L/5 Software: 1.38

Help! Triac PC 1996

Post by vpmayer » Tue 10 Jan , 2012 20:56 pm

I need help to startup a triac pc 1996,

a long time this machine was shutdown, and now, i will go used.

thanks

Martin
CNC Guru
CNC Guru
Posts: 1678
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Help! Triac PC 1996

Post by Martin » Tue 10 Jan , 2012 21:19 pm

vpmayer wrote:I need help to startup a triac pc 1996,
Can you be more specific?

vpmayer
Posts: 3
Joined: Tue 10 Jan , 2012 20:10 pm
Hardware/Software: TriacPC SN: EO4706M/3 Software: 2.93

MiracPC SN: EO4706L/5 Software: 1.38

Re: Help! Triac PC 1996

Post by vpmayer » Tue 10 Jan , 2012 21:52 pm

I don't know which software i need use.

i don't know how to install that software.

i don't know how this cable is conected.

i never used this machine. But i go fix this machine, and put it in operation.

thanks, une more time.

User avatar
Denford Admin
Site Admin
Posts: 3588
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Help! Triac PC 1996

Post by Denford Admin » Wed 11 Jan , 2012 13:25 pm

You will need some DOS software available from here:
http://website.denford.ltd.uk/support/9 ... s-software
Probably FanucMD for Triac..

Other useful info:
Triac PC Electrical Drawings 1995 / 96 / 97
viewtopic.php?f=15&t=2040

DOS software Operating manual:
viewtopic.php?t=1636

Your machines inspections sheet with parameter settings:
EO4706M3.pdf
(24.33 KiB) Downloaded 429 times

Post Reply