Socket pinout and sensor voltage
Posted: Sat 15 May , 2010 13:50 pm
Hi All
I´m finally getting to converting my 86 Triac to Mach3. Now, I intend to have the machine intact and just rebuild the electronics. The best way would be if I could just use the socket from the machine and connect to my new controlling system. I have done some searching here but I cant find the pinout from the socket. Is there anyone that can help me with this (the sockets on the picture just for clarification).
And if someone know the type of socket and from were I can buy it too, that would be even better..
Next question, does someone know what voltage the inductive sensors run on (agin the sensor on the picture for clarity)?
Thanks, Per
(selling my complete PNC3 system in the classifieds..)
I´m finally getting to converting my 86 Triac to Mach3. Now, I intend to have the machine intact and just rebuild the electronics. The best way would be if I could just use the socket from the machine and connect to my new controlling system. I have done some searching here but I cant find the pinout from the socket. Is there anyone that can help me with this (the sockets on the picture just for clarification).
And if someone know the type of socket and from were I can buy it too, that would be even better..
Next question, does someone know what voltage the inductive sensors run on (agin the sensor on the picture for clarity)?
Thanks, Per
(selling my complete PNC3 system in the classifieds..)