CAN I USE FANUC MD TO RUN THIS MACHINE OR DO I HAVE TO USE VR MILLING?
CAN I USE BOTH BT30 AND ISO TOOLING AS IT DOES NOT HAVE AN ATC?
MUCH THANKS FOR ANY HELP...
WHAT COMES WITH A 2000 TRIAC PC AS STANDARD
Moderators: Martin, Steve, Mr Magoo
WHAT COMES WITH A 2000 TRIAC PC AS STANDARD
I HAVE RECENTLY PURCHASED A 2000 TRIAC PC IM NOT SURE THE MACHINE IS COMING WITH THE RS232 CABLE TO CONNECT TO THE PC- IS THERE A WIRING DIAGRAM SOMEWHERE OR CAN I PURCHASE ONE CHEAP ENOUGH?
CAN I USE FANUC MD TO RUN THIS MACHINE OR DO I HAVE TO USE VR MILLING?
CAN I USE BOTH BT30 AND ISO TOOLING AS IT DOES NOT HAVE AN ATC?
MUCH THANKS FOR ANY HELP...
CAN I USE FANUC MD TO RUN THIS MACHINE OR DO I HAVE TO USE VR MILLING?
CAN I USE BOTH BT30 AND ISO TOOLING AS IT DOES NOT HAVE AN ATC?
MUCH THANKS FOR ANY HELP...
Hi,
I think the cable will be the IBM to Machine. Visit link below.
http://www.denfordata.com/downloads/dos ... agrams.zip
As for the tooling the spindle is BT 30 so BT so tooling can be fitted directly. The normal method however was to fit an EasyCHANGE toolholder to the spindle then you can quickly change tooling out.
Visit the thread below for info on the Easy Change tooling and supplier info.
viewtopic.php?t=1359&highlight=coventry
I think the cable will be the IBM to Machine. Visit link below.
http://www.denfordata.com/downloads/dos ... agrams.zip
As for the tooling the spindle is BT 30 so BT so tooling can be fitted directly. The normal method however was to fit an EasyCHANGE toolholder to the spindle then you can quickly change tooling out.
Visit the thread below for info on the Easy Change tooling and supplier info.
viewtopic.php?t=1359&highlight=coventry