Hi can anyone give me details on the steppers used on a Triac
current rating etc , as i am looking to update the Mach3 etc , so wondering which drivers would suit
regards
Dave
triac stepper ratings
Moderators: Martin, Steve, Mr Magoo
- davidimurray
- CNC Expert
- Posts: 194
- Joined: Thu 24 Aug , 2006 9:45 am
Thanks Dave ,
i am just in the middle of stripping it , to move it through a door !
not recomended for any sain person , so i should be able to get to the motors
i'll post the info on the plates hopfully tomorrow
it's never even had it's coat off before , so having a good peek and poke
had to remove the ATC and the Z axis , i would have hoped to just be able to
unplug the cable and gently remove them , but alas all the holes in the castings are smaller than the plug housings . i'd have liked to remove the head casting , just for lightening the load whilst moving it to a new location
Dave
i am just in the middle of stripping it , to move it through a door !
not recomended for any sain person , so i should be able to get to the motors
i'll post the info on the plates hopfully tomorrow
it's never even had it's coat off before , so having a good peek and poke
had to remove the ATC and the Z axis , i would have hoped to just be able to
unplug the cable and gently remove them , but alas all the holes in the castings are smaller than the plug housings . i'd have liked to remove the head casting , just for lightening the load whilst moving it to a new location
Dave