Hi All,
I am new to the forum so if I get something wrong let me know.
I have just got a Triac VMC circa 2000 with servo drives, the problem is that I have a low lube warning on the screen that I can not get rid of .
The manuals I got with it don't mention this and the lube oil tank is full.
I can not get a program to run at all, is flashes executing... and then stops, is this due to the warning?
The machine has not been powered up for years so is it possible it has lost some info about the setup of the machine?
I had to reset the bios as it was all messed up.
Thanks
Rasp
Low Lube
Moderators: Martin, Steve, Mr Magoo
- Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
so is this with a fanuc control?
sounds like the switch isn't connected have you checked it out?
sounds like the switch isn't connected have you checked it out?
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com