i have a Traic ATC mill 1988 with 21/2 degrees of motion, i am trying to use rhino Cam to do some CNC, can someone supply me with a correct post processor,
and Can it be upgraded to 3D of motion
Traic ATC mill 1988 help
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3632
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Can you supply some more details of the control/drive electronics, eg North East Electronics and the how its controlled (eg PC / BBC etc...)?
Anyone else who can help you out will need to know this.
I think its maybe too old to qualify for our Euro card upgrade route to enable smooth 3 axis interp, but if not that would give your machine a whole new lease of life.
If its the older North East stuff, then I guess you should look at replacing the control and drive electronics - there must be lots of others who have done this.
I'd look at the control hardware first before looking for a Post for Rhino
Anyone else who can help you out will need to know this.
I think its maybe too old to qualify for our Euro card upgrade route to enable smooth 3 axis interp, but if not that would give your machine a whole new lease of life.
If its the older North East stuff, then I guess you should look at replacing the control and drive electronics - there must be lots of others who have done this.
I'd look at the control hardware first before looking for a Post for Rhino