Starmill ATC - security key not connected
Posted: Wed 10 Jul , 2013 22:11 pm
Machine is circa 1990. Runs on DOS. Starmill.EXE starts on boot.
Errors out with "Security Key not Connected"
Dont think this is a physical key.
Any help will be appreciated. I eventually want to upgrade to VR Milling also run the software from another machine - say XP. Have been reading lots of posts here (forum is very helpful), but not sure whether this entails hardware upgrade as well.
Thanks.
Jai
Errors out with "Security Key not Connected"
Dont think this is a physical key.
Any help will be appreciated. I eventually want to upgrade to VR Milling also run the software from another machine - say XP. Have been reading lots of posts here (forum is very helpful), but not sure whether this entails hardware upgrade as well.
Thanks.
Jai