ATC or Tool post that fits Orac lathe

All info relating to the Denford ORAC CNC lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
oscilloman
Posts: 3
Joined: Thu 10 Dec , 2015 15:42 pm
Hardware/Software: Denford Orac

ATC or Tool post that fits Orac lathe

Post by oscilloman » Thu 10 Dec , 2015 20:33 pm

Hi

I am looking for a ATC or a newer type tool post that fits the orac lathe. I have been looking at wedge type tool post. And was hoping i could find one that fits the 10mm stud on the original compound. But i have not had any luck yet. So I was hoping maybe someone would know where i can find/buy something like this.

Thanks!

Post Reply