anyone have the opto sensor board schematic GSM PC1607
for Orac Lathe
and how to set the correct pulse , i have a feeling either the sensors not aligned or the timing is out , so looking for general info
Orac opto sensor board
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3632
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Orac opto sensor board
This might help:
viewtopic.php?f=43&t=3308
Have you searched all the Orac circuit diagrams - there may be more info in there
viewtopic.php?f=43&t=3308
Have you searched all the Orac circuit diagrams - there may be more info in there
Re: Orac opto sensor board
thanks found it !
- davidimurray
- CNC Expert
- Posts: 194
- Joined: Thu 24 Aug , 2006 9:45 am
Re: Orac opto sensor board
If it's the same as the one on the starturn (which I think it is) you need to supply the sensor with a 12v supply and you will get a 5v output from the signal lines.