Hi All,
I have a rather old orac that I ripped out all the old Denford Electronics and replaced with modern steppers and running Mach3. Things are going well but I'm trying to tune the motors, anyone got details on the screw pitches on the Z and X axis. or even better the settings for Mach3
Many thanks in advance
Wayne
Orac steppers and Mach3
Moderators: Martin, Steve, Mr Magoo
-
micromouse
- Posts: 1
- Joined: Fri 28 May , 2010 11:03 am
- Hardware/Software: Orac
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Orac steppers and Mach3
1000 steps per mm according to this
https://denfordata.com/bb/viewtopic.php? ... eps+per+mm
https://denfordata.com/bb/viewtopic.php? ... eps+per+mm