Customer says ...............
Orac has been relocated in a different room and now gets the following problems
1. The tool offsets do not seem to be remembered correctly, it will work fine once the offsets have been set, but on restarting the Orac the offsets are not correct
2. The spindle will only run at 50RPM
Any ideas anyone ?
Offsets not been remembered
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Offsets not been remembered
I didn't think the Orac remembered tool offsets anyway 
You can save and load them to micro tape though...
The low speed could be a loose or broken wire in the command to the spindle drive (ie it's enabled and running at minimum speed)
You can save and load them to micro tape though...
The low speed could be a loose or broken wire in the command to the spindle drive (ie it's enabled and running at minimum speed)
Re: Offsets not been remembered
Hi, my Orac doesn't remember tool offsets if power turned off, I thought that was normal.
All other functions work OK.
All other functions work OK.