Hello all, would an Orac 100mm chuck fit a new Novaturn lathe?
Many thanks,
David.
Would an Orac 100mm chuck fit a new Novaturn?
Moderators: Martin, Steve, Mr Magoo
-
Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
Suck it & see 
if not I'll give you something for the chuck
if not I'll give you something for the chuck
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
I am sure you can get an adaptor plate to make the chuck fit.
Do you have an automatic toolchanger?
If so you will have problems if you have any internal tools fitted in the turret disc as they will colide with the chuck jaws!
If you take out the internal tools there is no reason why you cannot use the chuck.
You should have enough clearance over the cross slide.
Do you have an automatic toolchanger?
If so you will have problems if you have any internal tools fitted in the turret disc as they will colide with the chuck jaws!
If you take out the internal tools there is no reason why you cannot use the chuck.
You should have enough clearance over the cross slide.
