Page 1 of 1
Noverturn motor ticking
Posted: Fri 07 Nov , 2014 12:32 pm
by cleemachining
My noverturn motor is making a ticking noise. But not all the time are the brushes on there way out . Are thay in stock
Re: Noverturn motor ticking
Posted: Tue 11 Nov , 2014 7:10 am
by Steve
Are you talking about the spindle motor? This will have brushes. The axes motors are steppers and brush free.
Re: Noverturn motor ticking
Posted: Sun 16 Nov , 2014 12:27 pm
by cleemachining
Sorry , Yes the spindle moter. It runs all ok just a on and of ticking , worse at faster spindle speeds . thanks
Re: Noverturn motor ticking
Posted: Sun 16 Nov , 2014 21:00 pm
by Martin
Can you you check the drive belt for swarf?
Re: Noverturn motor ticking
Posted: Fri 19 Dec , 2014 15:38 pm
by cleemachining
The belt is clean and in good nick . have made 2 - 300 more parts on it some times the ticking stops and then starts again . Thanks