Noverturn motor ticking

All info relating to the Denford NovaTurn CNC lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
cleemachining
Posts: 4
Joined: Fri 07 Nov , 2014 12:06 pm
Hardware/Software: denford noverturn

Noverturn motor ticking

Post by cleemachining » Fri 07 Nov , 2014 12:32 pm

My noverturn motor is making a ticking noise. But not all the time are the brushes on there way out . Are thay in stock

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1316
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Noverturn motor ticking

Post by Steve » Tue 11 Nov , 2014 7:10 am

Are you talking about the spindle motor? This will have brushes. The axes motors are steppers and brush free.

cleemachining
Posts: 4
Joined: Fri 07 Nov , 2014 12:06 pm
Hardware/Software: denford noverturn

Re: Noverturn motor ticking

Post by cleemachining » Sun 16 Nov , 2014 12:27 pm

Sorry , Yes the spindle moter. It runs all ok just a on and of ticking , worse at faster spindle speeds . thanks

Martin
CNC Guru
CNC Guru
Posts: 1750
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Noverturn motor ticking

Post by Martin » Sun 16 Nov , 2014 21:00 pm

Can you you check the drive belt for swarf?

cleemachining
Posts: 4
Joined: Fri 07 Nov , 2014 12:06 pm
Hardware/Software: denford noverturn

Re: Noverturn motor ticking

Post by cleemachining » Fri 19 Dec , 2014 15:38 pm

The belt is clean and in good nick . have made 2 - 300 more parts on it some times the ticking stops and then starts again . Thanks

Post Reply