X Axis Ballscrew 8mm x 2.5pitch???
Posted: Thu 31 Oct , 2013 10:45 am
Hi there,
I took off the cross slide on our Novaturn to find a very small ballscrew inside. It appears to be 8mm x 2.5 pitch whereas all the documentation I have read, and all the drawings I have seen say that the Novaturn should have a 16x5 ballscrew.
Does anyone know why this would be? Were the ballscrews upgraded to something stronger post 1997.
Best regards,
Tim Power.
Edit: Pic added. It has the correct bearings and 12mm journal you'd expect on a 16mm ballscrew but for some reason it is then coupled to an 8mm screw.
I took off the cross slide on our Novaturn to find a very small ballscrew inside. It appears to be 8mm x 2.5 pitch whereas all the documentation I have read, and all the drawings I have seen say that the Novaturn should have a 16x5 ballscrew.
Does anyone know why this would be? Were the ballscrews upgraded to something stronger post 1997.
Best regards,
Tim Power.
Edit: Pic added. It has the correct bearings and 12mm journal you'd expect on a 16mm ballscrew but for some reason it is then coupled to an 8mm screw.