VR Milling VR Turning using BobCad which Post to use

All info relating to the Denford NovaTurn CNC lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Locked
JSKRABA
CNC Apprentice
CNC Apprentice
Posts: 50
Joined: Sat 11 Nov , 2006 19:17 pm

VR Milling VR Turning using BobCad which Post to use

Post by JSKRABA » Mon 30 Jan , 2012 10:51 am

I am considering using BobCAD with VR Milling 2.3 and VR Turning :3D:
Does any one know which of the many posts that BobCAD/Cam has is best?

Does any one from Denford Support have an idea how I might know, is there a spec I could use.

User avatar
Denford Admin
Site Admin
Posts: 3595
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: VR Milling VR Turning using BobCad which Post to use

Post by Denford Admin » Mon 30 Jan , 2012 11:42 am

Have locked this as I feel it should belong in the post section:
viewtopic.php?f=16&t=3613

Locked