Page 1 of 1

Schematic Circuit Diagrams for the Novaturn

Posted: Mon 22 Feb , 2010 15:10 pm
by Steve
smartstep.zip
(235.13 KiB) Downloaded 143 times
Turn.zip
(617.18 KiB) Downloaded 1318 times

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Fri 13 Sep , 2019 18:20 pm
by MadeForThat
I only see half of the denstep card and half of the nextstep terminal blocks, does anyone have the upper side of the denstep and the lowerside of the nextstep? I am looking for specifically how the speed/feed pots are set up

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Mon 16 Sep , 2019 10:03 am
by Martin
Both bottom cards are the same so use the same connections.

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Mon 16 Sep , 2019 18:34 pm
by MadeForThat
thanks martin,
Perhaps this is a stupid question, but the "control voltage" on the machine tags just refers to the component voltage outputs, not the operating voltage of the the control card itself, correct?

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Tue 17 Sep , 2019 7:58 am
by Martin

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Sun 10 May , 2020 15:38 pm
by LucDav
Thanks for the schematics, i am currently trying to build a new set of electronics for my novaturn as none came with it. I am looking at the spindle drive and the encoder feedback does anyone have any ideas about the missing page 4? Is the encoder feedback converted into a tacho signal?

Re: Schematic Circuit Diagrams for the Novaturn

Posted: Mon 11 May , 2020 12:22 pm
by TDIPower
Have a look at the info for the Starturn 5 I think its the same 'british encoder' I looked into it a while ago as i am converting my ST5 to Novaturn control

http://www.denfordata.com/bb/viewtopic.php?f=46&t=585

http://www.denfordata.com/bb/viewtopic. ... sh+encoder

http://www.denfordata.com/bb/viewtopic. ... der#p10871