Draw bar force?
Posted: Thu 21 Nov , 2019 1:18 am
Does anyone know the draw bar force on the Nova mill?
I'm looking to build a Power drawbar that's different from the standard so want to check what forces are required.
The standard ATC uses 27 Bellville's compressed by 3mm when holding a tool. From my calculations that only gives 500N pull force which seems low.
I'm looking to build a Power drawbar that's different from the standard so want to check what forces are required.
The standard ATC uses 27 Bellville's compressed by 3mm when holding a tool. From my calculations that only gives 500N pull force which seems low.