Nova Mill with Den-step board

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
jcotton
Posts: 8
Joined: Wed 18 Mar , 2009 16:05 pm

Nova Mill with Den-step board

Post by jcotton » Thu 26 Mar , 2009 20:36 pm

I am getting very low ac voltage 'everywhere'. The Den-step board has a "5" on the L.E.D. Any hints for what to check ?

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1449
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Fri 27 Mar , 2009 0:20 am

5 is normal.

Where are you measuring the voltage?

What is the problem?

What software are you running?

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Post by bradders » Fri 27 Mar , 2009 8:47 am

Isn't a "5" Emergency Stop Asserted ? An "8" and a "2" are usually OK

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1449
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Fri 27 Mar , 2009 13:45 pm

I agree. If any number is displayed at least you know the card is running.

This means the logic supply is OK.

Post Reply