Hi
New to all this got my software up and going hopefully the machine and it will marry Saturday.
what I need now is a guide to programming or a good lesson or two, its totally different from the XYZ at work.
any tips ideas etc???
cheers
Alan
programming
Moderators: Martin, Steve, Mr Magoo
-
Alan W notts
- Posts: 8
- Joined: Tue 21 May , 2013 22:14 pm
- Hardware/Software: just purchased novamill software none 2.95 on machine label
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: programming
Is it this software ?
viewtopic.php?f=41&t=3458
viewtopic.php?f=41&t=3458