Please advise if the following machines with "on board" pcs can be upgraded to the latest software. Thank you.
MIRAC serial# E03709 A/1 build date: 5/1990
TRIAC ATC serial# Eo3589 build date: 6/1989
Mirac and Triac (1990) -can be upgraded ?
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Looks like you are out of luck - both these machines are based on the GSM / North East Electronics systems.
General rule of thumb is that pre-1994 are mainly to old to update to the latest VR windows operating software. (Thats not to say its impossible - just a lot more work and money needs to be invested in bringing the electronics up to date)
If the machine has a EURO-CARD rack system with a 3U baldor motion control card and a DOS PC (either 3U PC card, or external PC), then it can normally be upgraded quite easily with a new USB euro-control card.
PS - can the owner of the Triac tell us his DIP switch settings on the toolchanger SMCU card (if it has one)
General rule of thumb is that pre-1994 are mainly to old to update to the latest VR windows operating software. (Thats not to say its impossible - just a lot more work and money needs to be invested in bringing the electronics up to date)
If the machine has a EURO-CARD rack system with a 3U baldor motion control card and a DOS PC (either 3U PC card, or external PC), then it can normally be upgraded quite easily with a new USB euro-control card.
PS - can the owner of the Triac tell us his DIP switch settings on the toolchanger SMCU card (if it has one)