I am using a Mirac with DOS 2.25 software and I do not seem to be able to put comments into the g-code.
I have tried the usual ways (abc), (abc and ;abc
I just get junk and it looks like the parser tries to make g-code from the text.
Am I trying to do something that is not valid on this version of software?
Thanks
Graham
Comments in Mirac DOS G-code
Moderators: Martin, Steve, Mr Magoo
Re: Comments in Mirac DOS G-code
I think I have the answer:-
It looks like you have to have the comment at the start of the line so :-
N1 T0101 M8 (ROUGHING TOOL)
G00 X25. Z.25
is not valid but
N1 T0101 M8
(ROUGHING TOOL)
G00 X25. Z.25
works just fine.
Regards
Graham
It looks like you have to have the comment at the start of the line so :-
N1 T0101 M8 (ROUGHING TOOL)
G00 X25. Z.25
is not valid but
N1 T0101 M8
(ROUGHING TOOL)
G00 X25. Z.25
works just fine.
Regards
Graham