Microrouter will home but will not jog

All info relating to the Denford MicroRouter Compact small routing machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Secrest
Posts: 1
Joined: Fri 13 Jan , 2012 16:32 pm
Hardware/Software: Microrouter Compact/VR CNC Milling ver. 2.28

Microrouter will home but will not jog

Post by Secrest » Fri 13 Jan , 2012 16:36 pm

Running Windows XP and VR CNC Milling 2.28 This is the first problem with the machine. Any suggestions on what the problem might be? I have re-installed the software with the same results. I have also installed on another computer with same results.

Manual feed has been set to max with no effect.
Last edited by Secrest on Fri 13 Jan , 2012 16:58 pm, edited 1 time in total.

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Microrouter will home but will not jog

Post by Martin » Fri 13 Jan , 2012 16:46 pm

Check that the feed overide button is not on 0%.
Attachments
screen1.jpg
screen1.jpg (28.84 KiB) Viewed 7848 times

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Microrouter will home but will not jog

Post by Denford Admin » Mon 16 Jan , 2012 11:01 am

It's also worth checking the jog keys definitions haven't been tampered with:
viewtopic.php?f=8&t=729

Post Reply