TechTurn
Posted: Mon 20 Mar , 2023 18:28 pm
Greetings,
I have a Brodhead-Garrett TechTurn machine (see attached pic) with the esMINT/3.28 v1.6h/S-JD5 chip.
I am an IT guy with no experience running these machines but I am trying to get it working for the department that wants to use it.
I am going to connect the machine to a PC running a DOS VM with the proper software, then hand over to the department in question to actually use.
I am not sure which programs from the following page I need to download:
https://denford.co.uk/dos-vintage-machine-information/
I have looked at other posts on the forum and I think I at least need one of the Fanuc* programs.
Any help is appreciated.
I have a Brodhead-Garrett TechTurn machine (see attached pic) with the esMINT/3.28 v1.6h/S-JD5 chip.
I am an IT guy with no experience running these machines but I am trying to get it working for the department that wants to use it.
I am going to connect the machine to a PC running a DOS VM with the proper software, then hand over to the department in question to actually use.
I am not sure which programs from the following page I need to download:
https://denford.co.uk/dos-vintage-machine-information/
I have looked at other posts on the forum and I think I at least need one of the Fanuc* programs.
Any help is appreciated.