Micromill 2000 - RS232 Error

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Micromill 2000 - RS232 Error

Post by Benny » Tue 16 Oct , 2007 13:05 pm

Micromill 2000 NS

On connecting to machine, always get an RS232 error, but Lindy RS232 is connected. The green LED display shows a “2”. 1 LED lit on power card. I have replaced the 5 fuses and all appear to be ok. I have reloaded software VR CNC Milling 2.31 with no luck.
Top
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Micromill 2000 - RS232 Error

Post by Benny » Tue 16 Oct , 2007 13:06 pm

Customer checked fuse holder FS4, it was loose. Customer tightened up the fuse holder to clamp on the fuse tighter. Machine is running perfectly.
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Tue 16 Oct , 2007 15:24 pm

Always disconnect the power and leave the machine a few minutes before doing this. :oops:

If you then take the fuse out completely it is easy to nip the prongs together before refitting the fuse.
Top
Post Reply

Return to “Micromill / Microturn”