Easimill controller

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
RonGlock
Posts: 1
Joined: Thu 16 Nov , 2006 11:00 am
Location: Surrey

Easimill controller

Post by RonGlock » Thu 16 Nov , 2006 11:31 am

I have an Easimill that I purchased used that has a busted controller. Not sure how much is salvageable. I have been told that it is possible to use the stepper motors in the machine and new control cards with a PC to get the machine to function as intended but have no idea of cost or how to go about it. I also understand that the control manufacturers can supply me with a complete control panel. Need all and any advice on which way to go to get this machine up and running.

Thanks
Top
User avatar
davidimurray
CNC Expert
CNC Expert
Posts: 194
Joined: Thu 24 Aug , 2006 9:45 am

Post by davidimurray » Thu 16 Nov , 2006 12:54 pm

Hi

If it has a PNC2 controller you may want to have a look at ebay item 230050163948

Cheers

Dave
Top
User avatar
Denford Admin
Site Admin
Posts: 3635
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Fri 17 Nov , 2006 12:37 pm

Well worth getting this control off ebay for less than £100

Otherwise your looking at a £200-400 retrofit and a steep learning curve !
Top
Post Reply

Return to “EasiMill / EasiTurn”