Page 1 of 1
Easimill 3 electrical schematic drawing wanted
Posted: Mon 30 Mar , 2009 15:10 pm
by snadeau
I need the electrical schematic drawing of a Easimill 3
Model TDS/E/M/CNC
serial EO 2566
and if you have any information about the stepper motor.(voltage,amp,etc)
thanks
Posted: Tue 31 Mar , 2009 8:53 am
by Denford Admin
Posted: Tue 31 Mar , 2009 12:55 pm
by snadeau
Yes but on the first on i didn't see any link to download it.
and in the second that was only a maintenace manual.
and in the third that was software.
we want replace the controler and drive.
we want use the actual step motor.
thank to help me, i appeciate
Posted: Tue 31 Mar , 2009 13:32 pm
by Denford Admin
Yes but on the first on i didn't see any link to download it.
You must be logged in to see the download links (if not, then it could be a browser issue)
and in the second that was only a maintenace manual.
The maintenance manual has a spec sheet at the end that states:
Stepper motors ... 200 Steps/Rev, 3.5 Amps, 1.1 Ohms
There is a wealth of information here and on other forums for what you are wanting to do, however, you really need to sift through it all to get everything you need. No-one will have all the answers.
Posted: Tue 31 Mar , 2009 14:46 pm
by snadeau
thank a lot