Page 1 of 1
Alphacam post for Denford Cyclone
Posted: Mon 29 Aug , 2022 19:29 pm
by Bolan41
Hi all does anyone know if there is a Alphacam post for for a Cyclone lathe. I have just purchased this machine so all a bit new to me mostly ese cnc routers. Thanks
Re: Alphacam post for Denford Cyclone
Posted: Wed 31 Aug , 2022 1:35 am
by rasp
The Fanuc 15,18 or 21 post should work fine.
Re: Alphacam post for Denford Cyclone
Posted: Sat 03 Sep , 2022 6:36 am
by Bolan41
Hi thanks for the reply, what about the 6Tpost would that work?
Re: Alphacam post for Denford Cyclone
Posted: Sun 18 Sep , 2022 17:34 pm
by rasp
I will work as long as you do not use the canned cycles in Alphacam, The 6T post is single line canned cycles, the 0i,15 18i and 21i are all 2 line canned cycles unless you have the F15 option installed in the control.