new jaws

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
hpe
Posts: 22
Joined: Sat 13 May , 2017 7:53 am

new jaws

Post by hpe » Sun 03 Mar , 2019 20:08 pm

hi i have a cyclone and i need some external jaws for it ...i cannot see any manufacturer on the chuck just the numbers H13665 its 125mm with 35mm through hole 95mm recess

the jaws have 716 stamped on them

does anyone know what chuck i have and where to get jaws

cheers

jamesgates1000
CNC Apprentice
CNC Apprentice
Posts: 87
Joined: Sat 01 Aug , 2015 9:23 am
Hardware/Software: 2001 Cyclone with toolchanger and Fanuc 21i control
Serial number - H00913.
Voltage 415V F.L.C 20A 50Hz 3Ph

1997 Triac VMCwith toolchanger and Fanuc O-M control
Serial number - 70826B.
Voltage 415V F.L.C 30A 50Hz 3Ph

Re: new jaws

Post by jamesgates1000 » Thu 07 Mar , 2019 10:48 am

Mine was fitted with a Pratt Burnerd 125mm chuck with the same dimensions that you have.

I need hard jaws also, I found these on ebay...

https://www.ebay.co.uk/i/362560172564?chn=ps

I bought a nice new two piece jaw chuck for mine from cutwel for just over £300

https://www.cutwel.co.uk/workholding/sc ... 275-series

hpe
Posts: 22
Joined: Sat 13 May , 2017 7:53 am

Re: new jaws

Post by hpe » Fri 08 Mar , 2019 18:59 pm

thank you

do you or anyone know the taper on the spindle which locates the backplate for a chuck ?

DavidB
CNC Expert
CNC Expert
Posts: 173
Joined: Tue 19 Oct , 2010 16:06 pm
Hardware/Software: Triac, Orac

Re: new jaws

Post by DavidB » Fri 08 Mar , 2019 21:40 pm

The data for the Cyclone here viewtopic.php?f=33&t=3823 says the spindle is A2 3" and some data here about the dimensions http://www.lathes.co.uk/spindlenose/spindlenoses.pdf . From memory the taper is 1 in 4 on diameter but worth a bit of simple trigonometry to check against the taper shown.

User avatar
Lone_Ranger
CNC Expert
CNC Expert
Posts: 220
Joined: Mon 01 Oct , 2007 15:23 pm
Contact:

Re: new jaws

Post by Lone_Ranger » Fri 08 Mar , 2019 23:23 pm

Could possibly be a Bison/Toolmex chuck, if you measure one of your jaws up, length, width, slot and screw pitch and go to the Rotagrip site there is a fair chance you will find the right jaws for your chuck, I got all my stuff from them when I had my 2 Cyclones a few years ago. Link here :-

http://www.rotagriponline.com/index.php ... &Itemid=29

Regards
Rob

Post Reply