Replacing Fanuc Servo Batteries Tip

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
jamesgates1000
CNC Apprentice
CNC Apprentice
Posts: 87
Joined: Sat 01 Aug , 2015 9:23 am
Hardware/Software: 2001 Cyclone with toolchanger and Fanuc 21i control
Serial number - H00913.
Voltage 415V F.L.C 20A 50Hz 3Ph

1997 Triac VMCwith toolchanger and Fanuc O-M control
Serial number - 70826B.
Voltage 415V F.L.C 30A 50Hz 3Ph

Replacing Fanuc Servo Batteries Tip

Post by jamesgates1000 » Wed 04 Jan , 2017 21:17 pm

I had to replace the Servo back up batteries a while back and found that the recommended batteries that fit in the little yellow holder worked out really expensive.

https://bestbattery.biz/index.php?optio ... oCmIjw_wcB

So I got a pair of these...

http://www.hardwarexpress.co.uk/csb-gp6 ... oCpYLw_wcB

I soldered some spade connectors to the connector that i cut off from the old battery and cable tied them in.

Worked out at £22 delivered, roughly half the cost and double the Ah of the original batteries.

Post Reply