The buttons along the bottom ofthe Fanuc screen

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Bolan41
Posts: 12
Joined: Mon 29 Aug , 2022 10:31 am
Hardware/Software: Denford Cyclone/Alphacam

The buttons along the bottom ofthe Fanuc screen

Post by Bolan41 » Tue 18 Jul , 2023 19:18 pm

Hi,
The buttons along the bottom ofthe Fanuc screen Do they only work on certain controllers, I have a Fanuc ot-b but the buttons don’t light up or seem to function and also the graphic display of the tool paths can’t get that up either. Thanks

User avatar
rasp
CNC Expert
CNC Expert
Posts: 126
Joined: Wed 06 Feb , 2008 18:33 pm

Re: The buttons along the bottom ofthe Fanuc screen

Post by rasp » Sun 20 Aug , 2023 1:57 am

They are Fanuc options, if you have the original parameter list check it against the settings in the control.

pfp
Posts: 24
Joined: Mon 21 Dec , 2015 1:24 am
Hardware/Software: Denford zeroturn Fanuc OT

Re: The buttons along the bottom ofthe Fanuc screen

Post by pfp » Mon 04 Sep , 2023 20:15 pm

you can enable them . Do you have 2 screens to do with your tools to set offsets etc.

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: The buttons along the bottom ofthe Fanuc screen

Post by Martin » Tue 05 Sep , 2023 10:51 am

I think they were all options but the graphics required a new card fitting.

If you can find the original 900 parameters it would be worth checking.

Post Reply