Could you help get me started on my MRC40?
Posted: Thu 17 Dec , 2020 14:37 pm
Hi,
I recently bought a used Denford MRC40, and after successfully making a small maze using the built in tutorials, I am now trying to make one of my own designs.
I'm not a total idiot (depends who you ask) and have been using my own laser cutter for a decade, so should be able to get going with a bit of help.
Rather than write dozens of messages in a thread , 'have you tried this?", "yes", "what about this?", "yes" etc etc which could take weeks, what would really help is if someone could do a 1 to 1 facetime/skype call with me for about 30-45 mins to walk me through it. I would be happy to pay for your time. £50/hour ok?
Is anyone able to do this for me? I would be so grateful.
Thanks,
Fred
I recently bought a used Denford MRC40, and after successfully making a small maze using the built in tutorials, I am now trying to make one of my own designs.
I'm not a total idiot (depends who you ask) and have been using my own laser cutter for a decade, so should be able to get going with a bit of help.
Rather than write dozens of messages in a thread , 'have you tried this?", "yes", "what about this?", "yes" etc etc which could take weeks, what would really help is if someone could do a 1 to 1 facetime/skype call with me for about 30-45 mins to walk me through it. I would be happy to pay for your time. £50/hour ok?
Is anyone able to do this for me? I would be so grateful.
Thanks,
Fred