error no response from controller

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
papa_dogo
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Sat 08 Jun , 2013 0:54 am
Hardware/Software: microturn/vr turning/lathecamdesigner
micromill/vr milling

error no response from controller

Post by papa_dogo » Thu 28 Sep , 2017 13:07 pm

getting this error message soon after starting the program: error no response from controller. vr milling 2 on a microrouter v4ns. only way out is to disconnect the machine.

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: error no response from controller

Post by Martin » Thu 28 Sep , 2017 22:12 pm

Are you running any local extraction as it could be causing electrical noise.

It may be worth loading DenfordEasyUpgrader & checking the firmware is up to date on the NextStep control card.

Post Reply