Page 1 of 1
Toolin library
Posted: Wed 22 Jan , 2014 15:41 pm
by philipb
We have just re-installed VRMilling to a replacement computer and up-dated the software to V5.55. All appears to working ok but there is only one tool the tool library (6mm ball nose (default)). From memory I thought this was pre-populated with a large range of tools. Any help please.
Re: Toolin library
Posted: Wed 25 Jan , 2017 17:23 pm
by jams138
I realize that the previous post is a few years old, but I now have the same situation. A customer of mine has recently upgraded to VR Milling V5.64, and now in his tooling library, the 8MM End Mill tool is not available for selection. Is there a way to add this tool to the library or a procedure that is needed to reveal it as available?
Thank you.