Microrouter Compact
S/N #u00565/1
Elect.#u0504260460
Jult 2005
VR Milling v5.7
Techsoft 2D
Windows XP
When running the program in 2D/3D simulation, the cutting cannot be seen and at some point during the simulation Zig Zag lines appear in Red, and the script portion of the piece is not where it is suppose to be. We don't want to run the piece with such erratic simultion.
Erractic Simulation in VR Milling v5
Moderators: Martin, Steve, Mr Magoo
With the simulation window open.
Click on the simulation window header and you will see that the menus available at the top of the screen change to give a simulation menu.
Select Simulation then Billet materials.
Change the resolution to fine.
This will slow down the simulation but improve the picture quality
Click on the simulation window header and you will see that the menus available at the top of the screen change to give a simulation menu.
Select Simulation then Billet materials.
Change the resolution to fine.
This will slow down the simulation but improve the picture quality