Motor drives
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 7
- Joined: Mon 11 Feb , 2013 11:23 am
Motor drives
Having trouble with Drive on CNC 3 (1986) Had two boards repaired But the fuses keep blowing on the motor drive board. Any suggestions. Display says Motor Drive fault in 'x'
Re: Motor drives
Can you post some pictures please? Not sure what a CNC 3 is!
-
- Posts: 7
- Joined: Mon 11 Feb , 2013 11:23 am
Re: Motor drives
RThanks for the reply. Camera not working at moment. It is the Easymill 3 CNC. It is behaving similar to Ollies query. red lights on the only board that is working, which incidentally does work in the other two slots on the board.
-
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: Motor drives
sounds like cd20/30
ps. make sure you turn the power off before removing or connecting the drives.
ps. make sure you turn the power off before removing or connecting the drives.
-
- Posts: 7
- Joined: Mon 11 Feb , 2013 11:23 am
Re: Motor drives
THANKS. ONE DRIVE WORKING IN ALL THREE SLOT OTHER TWO SHOWING RED LIGHTS.
Looks like two duff ones. Any ideas.
Looks like two duff ones. Any ideas.