Triac PNC 3 Imperial mode post processor

Anything to do with configuring CAM systems and Post Processors to run on different CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Triac PNC 3 Imperial mode post processor

Post by Denford Admin » Fri 03 Sep , 2010 10:50 am

I've created an imperial PNC post processor attached.
Just add the file to this directory:
C:\Documents and Settings\All Users\Application Data\Denford\Posts

Please let me know if it works ok and it will go onto the next releases.
Attachments
Triac PNC (Inch).ppl
(1.42 KiB) Downloaded 1105 times

Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

Re: Triac PNC 3 Imperial mode post processor

Post by Large519 » Thu 16 May , 2013 23:29 pm

Can you make a metric processor for the pnc3, and will it run in mach3

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Triac PNC 3 Imperial mode post processor

Post by Denford Admin » Fri 17 May , 2013 8:55 am

The metric version was done first (in 2006!) so will already be on any Denford CAM software
Attachments
Triac PNC.ppl
(1.41 KiB) Downloaded 880 times

Post Reply