Magoos reading material ?

If you've had enough of reading, then look at these pictures of the "good" old days. Machine brochures, magazines etc..

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3595
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Magoos reading material ?

Post by Denford Admin » Fri 01 Dec , 2006 12:57 pm

Found this stashed away as I was looking for PABs DIP switch settings - enjoy :shock:
Attachments
amateur-photographer-1984.JPG
amateur-photographer-1984.JPG (145.85 KiB) Viewed 7639 times

User avatar
Mr Magoo
CNC Guru
CNC Guru
Posts: 301
Joined: Tue 21 Feb , 2006 21:45 pm
Location: Brisbane, Australia

Post by Mr Magoo » Sat 02 Dec , 2006 8:57 am

Mmmmm....

I've just been working out my start date at Denfords - 1986

So unfortunately can't claim this one as mine

Which begs the question, who was the 'amateur' photographer :?: :?: :?:

VIC
Posts: 2
Joined: Sat 21 Jul , 2007 18:51 pm
Location: SKIPTON

That's My Magazine

Post by VIC » Fri 11 Apr , 2008 20:21 pm

You've been going through my old papers !!!!!!

The magazine you have found was once mine, I did not buy it but found it among other reading material about the date shown.

I'am not an amateur photographer but the sight of those long...long...legs stopped me from throwing it away.

Ian Vickery

:shock:

User avatar
Denford Admin
Site Admin
Posts: 3595
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Mon 14 Apr , 2008 8:44 am

those long...long...legs stopped me from throwing it away
I'd totally agree with that :wink:

PS - glad to see you on here

User avatar
Mr Magoo
CNC Guru
CNC Guru
Posts: 301
Joined: Tue 21 Feb , 2006 21:45 pm
Location: Brisbane, Australia

Post by Mr Magoo » Wed 16 Apr , 2008 6:58 am

Same from me Ian - good to hear from you...
found it among other reading material
So what happened to the other reading material

MFaulks
Posts: 2
Joined: Mon 28 Jul , 2008 21:33 pm
Location: London UK

Post by MFaulks » Mon 28 Jul , 2008 21:43 pm

This really brought a smile... it takes me back... my late father loved AP magazine, and the annual specials were a must, as I remember it there were very few pictures of flower pots!

Thanks for the smile and triggering fond memories :wink:

Post Reply