Hi

i replaced all capacitors marked with red and the rectifiers marked in yellow
and i dident see any deformations on them just went all in (almost)

//sven

Yihaaaa

I´v got my machine working again, i took the time and changed the capacistors and some tantal and even the rectifiers

and put them back and the mill started up just as it should

//sven

Hi i would like to wake this thread again now i trying to get my triac vmc back to life again, and i still wonder if both led´s shall light up on the custom card when i switch on the power? from time to time when i switch the power on the red 8 appear on the controler card but a half minut later it ...

hmm dont realy know where to find the error/errors

but shall both the led´s be on when powerup the triac see the image?
can someone pinpoint measure points on this card?
is there a schematic for this card ?
are all the cards made by baldor?
[img]powersource.jpg[/img]

all help is wanted

//sven

i removed the rightside relay 24v in the group of 3. cleand oxide . then spammed the e-stop suddenly the table stop moving and the red segment displayed first an 0 then 8 and was happy for 30 sec then the 8 dissapered and the table started to move again . then i connected an disconnected the power s...

i have been taken them out from the backplane and pushed them in and connected the cable´s again is this
the way to reset them?
if so i done it but no luck the feed is still on x and y as fast i turn on the main switch

//sven

hi

no i dont think so its just the lover part in the middle to the bottom and it lights poorly


//sven

Hello i have a triac vmc ser no: E0 4368 Year : 1994 with red segment display (baldor) it has been standing a unused a couple of year now and when i tried to get it to work again it fails when i connect the power both x & y axis start to move slowly out and to the left. the red segmented display sho...