Hi,
It is used on a Denford Triac, it is an SEM type 30X2-44L spindle motor.
REgards,
Dave.

Help please! I have a problem with a Parker SSD 508 Analogue DC Drive. I have used it for about 5years, it developed an intermittent fault which caused it to go completely dead. I found the fault which was a dry joint on the primary side of the small mains transformer. I managed with some difficulty...

Thanks to help from Martin I have now got the motor working, however it works well using the armature control setting, but it goes unstable when I connect the tacho output to the controller. I will have to look at this later it won't stop me using the machine. My next quest is to check the brushes a...

I was hoping someone might recognise this breakout board,
I wired it about five years ago and can't find any details of the connections.

Thanks Martin that is perfect, I'll be able to sort this out now.
Thanks again and happy Easter.
Dave.

Thanks very much.
I know the armature wires which seem to have an earth wire,
but how can I identify the others?

I am having difficulty find information on a SEM type 30X2-44L spindle motor ( Photo of plate enclosed) can anyone help with information on identifying the wires coming out of the motor. I have contacted SEM themselves who claim to had destroyed all information on obsolete motors can anyone please h...

Bottom left hand corner

If this is not good enough I will re-take the photo

I am very grateful of your help

Dave Mann

I have a Denford CNC Triac which I am coverting to run on mac3, with a SEM type 30X2-44L spindle motor The driver is a LYNX 08 I am having trouble getting it to work The manual for this drive found on the net is slightly different to mine I have attached a photo of the driver Can anyone identify it ...

I am converting a Triac for mac3 operation. I am keeping the power supply and stepper motors What is the most suitable size of driver and break-out board? Thanks Dave Mann P.S any information on the conversion would be great I have some details on the motors used on this machine:-MHY200 3424 310 A8...

I have a Denford CNC Triac which I am coverting to run on mac3, with a SEM type 30X2-44L spindle motor ( Photo of plate enclosed) can anyone help with information on running this motor when I replace the drives
Thanks
Dave Mann

I am converting a Triac for mac3 operation.
I am keeping the power supply and stepper motors
What is the most suitable size of driver and break-out board?
Thanks
Dave Mann
P.S any information on the conversion would be great