Hi Graham,
Good news, i bet you were
I would help if i could but i think you are on the next level to me
I have the fanuc manuals if they will be of any help, they are for the om and ot?

john

Its a funny world, turned the spindle circut breaker off and fired it up same error, turned it off, turned breaker on felt a bit strange, fired it up, all works now spindle drive lights on and runs. Funny thing is i tried this yesterday :roll: It must be the circut breaker, i will give them a good c...

Hi Guys, thanks for the help. Graham, the 24v psu is fine, i checked it bang on 24v. Lights and limits work all powered by 24v. You wanted some info, pm me your tel no and i will give you a call. I will check the electrical connections, but wiring said axis and spindle drives powered from same point...

Hi all,
Powered up the machine today and got 1008 spindle drive error.
All axis move and the machine homes, atc turns.
Drawbar wont open and spindle wont turn on strange.
I looked at the spindle board and there are no led's on, is this ok?
any help would be appreciated.
John

Hi All, Machine all up and running and drip feeding, very happy :D I have got the manuals with all the parameters as well, I don't have time to scan them but if anyone needs any info just drop me a message and i will be happy to help. One other thing, I tried to change the spindle belt to the higher...

Thanks for that, a lot to digest.

I managed to talk to the previous owner and he is sending me all the manuals and even the wiring diagram and a few spare pull studs for reference, happy days

I will scan and send denford the info when i get it to put on this website for everyone.

John

Thanks for the reply, I have found out a iscar part psbt4045m16 is the one but there are a few different types.

Another thing is how to connect up to a pc to drip feed ? what cable and software i need?

Thanks in advance for any help

John

Hi All, new to this forum.

I just bought a zero center and need some help.

Can anyone tell me what pull studs to use? my machine did not come with any tooling so i have no reference.

Thanks

John

Hi, I am looking for a Denford triac if possible with an ATC.
Machine to be in good condition not to worried about the electronics as I intend to upgrade them.

John@ardcor.co.uk

Thanks
John